AMBROSOL Stain Cover Spray 500ml - White

SHRUB COVER – It’s a formulate that gives high hiding power after just one coat to completely eliminate any stain at all by penetrating deep below the surface and then creating a seal for the prevention of new stains. Suitable for all stains caused by smoke on walls, mildew, and dirt in general. The STAIN COVER covers any stain when applied evenly over the area to be treated. The removal of particularly “resistant” stains may require repeated application of product always from a distance of 20-30 cm, paying attention to avoid runs. The product dries in 5-8 minutes if applied at a temperature of 20°C.

Technical Specifications:

• Quantity 500 ml
• Box / Case 12 Pcs
• Aspect Tin-Plate can containing under pressure fluid
• Chemical nature Quick drying acrylic paints
• Colour White
• Odour Characteristic of solvent
• Relative density at 20°C 0,77 ÷ 0,81 g/ml Primer e Antirust
• Flash point Und. 0° C extremely flammable
• Writing on spray bottom Barcode, Batch date, product name
• Pressure at 20°C 5,5 ± 0,5 bar
• Viscosity Ford cup from 13’’ to 18’’
• Dry residual in spray 46% (on dry film)
• Gloss From 5 to 10 Gloss (Glossmeter angle 60°)
• Thickness 1 coat 13-24 Micron
• Thickness 3 coats 36-54 Micron
• Resistance temperature -10°C / +130°C (Peak 150° C)
• Drying time t=20°:
• Out dust: 8-10 minutes
• Dry to touch: 30 minutes
• Dry in full depth: 22 hours
• Overcoating Interval: 22/48 hours
• It is possible to have different type of dispenser for various effects and employ

HOW TO USE: The surface must be completely dry. Shake the spray vigorously at least for 1 minute, until you feel the balls move
freely. It is also advisable to occasionally shake the spray even during the use. Test in a hidden area to check its compatibility with the
support to be painted. Apply a light first coat to improve coverage and adhesion to avoid the possibility of dropping. The application
distance is about 20 cm; after a few moments apply a second horizontal coat immediately followed by a third vertical coat; let it dry for a few minutes; after use, it is advisable to spray for 2/3 seconds with the spary can upside down, to prevent the the block of nozzle. Particularly indicated on white walls.