SPRAYGUN Headlight Bulb SET

Restores the headlights of cars to their original state.

The 600ml liquid is enough for about 15 car lights (7 cars).
Its lifespan is more than 3 years.

Product characteristics:

• Designed to restore transparency to yellowed or fogged headlights in a simple and easy process and return them to their original condition
• It improves the performance of the traffic lights and therefore driving safety.
• Easier solution than replacing the lights and much more economical.
• Can be used on all lights (headlights, fog lights, direction lights).
• Large initial packaging of glazing fluid -600gr- which is sufficient for approximately 15 car headlights (7 cars).
• Possibility of supplying only the liquid as a spare part for even greater economy.
• Long shelf life (more than 3 years)

KIT CONTENTS

•   Polycarbonate liquid 600ml
•   Heating vessel (lamp)
•   Plastic cap with curved fixed spout
•   Plastic cap with flexible mouth (tube) for difficult places
•   Power cable 2 meters

CAUTION

ALWAYS WEAR GLOVES, MASK AND GOGGLES WHEN USING IT

APPLICATION PROCEDURE

• We map the area around the traffic lights with paper tape
• We sand the lanterns with water blotting papers and water starting at P320 or P600 depending on the condition of our lanterns. We proceed with tissue paper P800, P1000, P1500, P2000 & P3000. The sanding must be diligent and uniform over the entire surface of the lantern.
• We place the chemical in the lamp above the middle of the container because otherwise there is a risk of burning the heating resistance.
• Close the heating container with one of the two lids and wait for about 4-5 minutes for the liquid to boil.
• When we see that the steam has started to come out of the mouth, we approach the lantern at a distance of about 5cm starting from the bottom upwards in a horizontal movement left-right and we go up with slow movements without leaving any gaps.
• In less than a minute we are done and after 10 minutes our lantern is ready.